Modules

In-Circuit Test

AMU05

Analog Measurement Unit – heart of the system

The AMU05 (Analog Measurement Unit 05) is the core of all our test systems. It ensures that all the measurements are performed faster, more accurately and with even greater stability.

more

FailSim

Improves the quality of your test programs

When it comes to the test coverage of a program in the analog ICT, the question is not only whether there is a test for every component and if it was performed, but also whether the test would in fact recognize a fault.

more

MUX

Switching matrix

The Analog Signal Switch Unit serves as a 6-bus interconnect for 128 pins each to the Analog Measurement Unit (AMU05) for the In-Circuit test.

more

HYB04

128-Pin hybrid driver/sensor module

The HYB04 enables comprehensive analog as well as digital driver- and sensor-functions. It has 128 non-multiplexed hybrid pins per module.

more

HYB03

64-pin hybrid driver/sensor module

Our HYB03 enables comprehensive analog as well as digital driver- and sensor-functions. It has 64 non-multiplexed hybrid pins per module.

more

Functional test

UCB

Our universal carrier for function modules

All function modules are plugged into our Universal Carrier Board (UCB) – with four slots available per carrier.

more

MTC

Measures frequencies and times

The MTC is responsible for measuring frequencies and times.

more

MOC

Universal control outputs

The MOC is our universal control module for a wide variety of tasks, such as controlling relays in the fixture.

more

MRM

Relays for free circuits

Our MRM is a relay card for universal connection of many kinds of signals.

more

MRD

Programmable resistor

The MRD permits connection of a programmable resistor to the test object.

more

MSM

Stimulate and measure voltages and currents

The MSM measures and stimulates precise voltages and currents through the six bus lines or interface pins.

more

MDS

Digitaler I/O mit 16 Kanälen

The static driver sensor module (MDS) is used to replace existing TS02 from previous MTS test systems. The possible pin extension allows to replace the systems MTS 200/210 (4 UCB with 4 MDS = 256 pins). A maximum of 1,024 MDS pins can be realized on the current MTS systems. Up to 4 MDS modules can be connected to one UCB (UCB03 or higher).

more

UPC02

Potential-free voltage source

The Universal Power Controller (UPC02) provides an independent potential-free voltage source for powering the test object, whereby the output voltage and current limiting are freely programmable.

more

You want to know more about our services?

Please contact us
Stay well informed